Search results for "Flicker noise"
showing 10 items of 22 documents
Measurement of the activation energies of oxygen ion diffusion in yttria stabilized zirconia by flicker noise spectroscopy
2019
The low-frequency noise in a nanometer-sized virtual memristor consisting of a contact of a conductive atomic force microscope (CAFM) probe to an yttria stabilized zirconia (YSZ) thin film deposited on a conductive substrate is investigated. YSZ is a promising material for the memristor application since it is featured by high oxygen ion mobility, and the oxygen vacancy concentration in YSZ can be controlled by varying the molar fraction of the stabilizing yttrium oxide. Due to the low diameter of the CAFM probe contact to the YSZ film (similar to 10nm), we are able to measure the electric current flowing through an individual filament both in the low resistive state (LRS) and in the high r…
Influence of oxygen ion elementary diffusion jumps on the electron current through the conductive filament in yttria stabilized zirconia nanometer-si…
2021
Abstract The structure of the electron current through an individual filament of a nanometer-sized virtual memristor consisting of a contact of a conductive atomic force microscope probe to an yttria stabilized zirconia (YSZ) thin film deposited on a conductive substrate is investigated. Usually, such investigation is performed by the analysis of the waveform of this current with the aim to extract the random telegraph noise (RTN). Here, we suggest a new indirect method, which is based on the measurement of the spectrum of the low-frequency flicker noise in this current without extracting the RTN, taking into account the geometrical parameters of the filament. We propose that the flicker no…
Electrical and optical low frequency noises in multimodal vertical cavity surface emitting lasers
2006
Experimental investigations of the low frequency noise of multimode 780 nm vertical cavity surface emitting lasers are reported. Electrical noise, optical noise and their correlation have been measured in the frequency range 1 Hz–95 kHz. The results show that the main contribution to the electrical noise is located in the distributed Bragg reflector layers of the laser. The optical power and pump current noise sources are strongly correlated below and around the threshold, while are weakly correlated above threshold. It is argued that the noise in the optical power is due to both free injection carrier noise and optical gain fluctuations.
DC and 1/f noise characterization of cryogenically cooled pseudomorphic HEMT's
2002
Pseudomorphic (AlGaAs/InGaAs/GaAs) HEMT's have exhibited the best noise performance over the entire LF-to-microwave frequency range if compared to MESFET's and conventional GaAs HEMT's, due to either a reduced flicker noise, a lower G/R contribution and a smaller high-field diffusion noise. We have recently investigated the microwave (up to 18 GHz) noise properties of packaged pseudomorphic HEMT's from 290 K down to cryogenic temperature values. The current experimental work is aimed at extending such analysis to the LF noise range and at low temperatures. Cryogenic noise spectra (1 Hz to 100 KHz) and DC characteristics have therefore been recorded and the relevant observations on the devic…
Ultra-Low Noise Multiwalled Carbon Nanotube Transistors
2013
We report an experimental noise study of intermediate sized quasi ballistic semiconducting multiwalled carbon nanotube (IS-MWCNT) devices. The noise is two orders of magnitude lower than in singlewalled nanotubes (SWCNTs) and has no length dependence within the studied range. In these channel limited devices with small or negligible Schottky barriers the noise is shown to originate from the intrinsic potential fluctuations of charge traps in the gate dielectric. The gate dependence of normalized noise can be explained better using ballistic the charge noise model rather than diffusive McWhorter’s model. The results indicate that the noise properties of IS-MWCNTs are closer to SWCNTs than th…
Langevin Approach to Understand the Noise of Microwave Transistors
2004
A Langevin approach to understand the noise of microwave devices is presented. The device is represented by its equivalent circuit with the internal noise sources included as stochastic processes. From the circuit network analysis, a stochastic integral equation for the output voltage is derived and from its power spectrum the noise figure as a function of the operating frequency is obtained. The theoretical results have been compared with experimental data obtained by the characterization of an HEMT transistor series (NE20283A, by NEC) from 6 to 18 GHz at a low noise bias point. The reported procedure exhibits good accuracy, within the typical uncertainty range of any experimental determin…
Advanced PSA Bipolar Transistors for Wireless Applications: Measurements of Scattering Parameters and Noise Figure
1994
A complete investigation on the performance of a series of double polysilicon self-aligned (PSA) bipolar transistors in terms of scattering parameters and noise figure is here reported. The devices have been characterized over the 1-4 GHz frequency range in several bias conditions to the aim of assessing the optimum bias values for the best trade-off between noise and gain performance. This is the first part of an extensive investigation currently performed on 5 families of PSA devices having different emitter configuration and size which have been manufactured by SGS-Thomson to undergo a comparative analysis on the global transistor performance.
A Method for Accurate Measurements of Optimum Noise Parameters of Microwave Transistors
1985
A method for measuring losses of the tuner network used as noise source admittance transformer in transistor noise parameter test-set is presented. Since the method is based on noise figure measurements, tuner losses can be determined on-line while performing measurements for determining transistor noise parameters. As experimental verifications the optimum noise parameters of a GaAs FET in the 4 - 12 GHz frequency range, measured through a computer-assisted measuring system, are reported.
Influence Of The Model Parameters On The Noise Performance Of Double-polysilicon BJTs For Microwave LNA's
1997
In the recent post we have measured the noise and the scattering parameters of several series of double polysilicon BJT's over the 2-6 GHz frequency range at different collector current values, according to their emitter finger number. From the experimental data, a noisy circuit model has been extracted based on a T-equivalent network. By means of the correlation matrix techniques, novel analytical expressions of the noise parameters have been derived. As a second step, a sensitivity analysis has been performed for evaluating the influence of each model element on the noise performance. The results show how to improve the characteristics of such devices for a better performance when employe…
Comparison between two measuring methods for complete characterization of low-noise HEMTs at microwaves
1996
The good performances of a set-up for the complete characterization of HEMTs up to 40 Ghz in terms of noise and scattering parameters through noise figure measurements only are shown by many experimental results. Because of some inconveniences in practice the use of the method is suggested for research laboratories only. For industrial applications an alternative symplified method is proposed whose performances are shown to be in surprising agreement with the ones of the standard method.